Horstronic Joystick – Panel / PCB set

From: £26.00

EU Price does not include EU VAT.

Omter Joystick Unit – optional

In stock

Thonkiconn Jacks with Knurled Nut × 4 – optional

In stock

VERTICAL: B100K - 100K Linear × 4 – optional

In stock

Dark Blue (6.35mm Round Shaft) × 4 – optional

In stock

Insufficient stock

SKU: Bundle_PP_Horstronic_Joystick Categories: , , , , ,

Description

This is a Panel and PCB set to build a Horstronic 14hp Joystick module. There is no build doc provided, but it has a BOM, good photos (linked below) and a build thread on Muffwiggler.

The joystick can output X and Y axes of CV, so can control two different CVs at once. It can either be used to scale/offset/attenuate incoming signals OR to generate control voltages without any input purely on the position of the Joystick.

The joystick is sprung so it always returns to centre, but this can be removed so the stick stays stationary and holds it’s position.

It not only has a CV output per channel but also an input. Depending on the position of the unipolar/bipolar switch (labelled + and +/-) you can use the joystick to alter the signal from nothing to full on in + mode or from inverted to 0 (in middle position) to full on in +/- mode.  Both channels also have an offset and a scale potentiometer which gives you the ability to offset the signal from -5V to +5V or scale it from inverted to full on before going through the joystick.

BOM – joystick-bom-0-9b-1

Build Thread – click here

You may also like…