Zlob Modular – Dual Analog VCO Panel / PCB Set


Powerful & stable dual VCO/LFO in a small footprint

Note: this is a Panel/PCB Set only – for complete kit go here

EU Price does not include EU VAT

Out of stock - Join the waitlist to be emailed when this product becomes available

SKU: PP_Zlob_Dual_VCO Categories: , , , ,


The Dual VCO is a 4hp dual voltage controlled analog oscillator. Each VCO has square, triangle, and sine wave out, coarse and fine tuning controls, a control voltage input, and a switch for selecting between exponential or linear CV in. When a control voltage is inserted, the fine tune control becomes an attenuator for the incoming voltage. Each VCO runs from 5 seconds a cycle up to 18khz.

Note that there are two main quirks with this oscillator design: Below 300hz the waveform symmetry is slightly off. Triangle waves get a little uneven in the LFO range and the square wave turns slightly more trapezoidal above 1khz. Both VCO’s track 1 volt per octave almost perfectly – usually the 2nd and 4th octave will be a couple cents off. Other than these idiosyncrasies, this is a powerful and stable pair of analog VCO’s in a small footprint with no cross talk between the oscillators. It’s great for: drones and beating sine or triangle waves, cross modulating itself for interesting clocks/LFOs, creating complex waveforms/timbres through lin/exp frequency modulation.

Dual VCO Build Document – Assembly Guide

Dual VCO BOM – Bill of Materials

(pcbs come with smd matched transistors pre-soldered)


  • Each VCO runs from 0.2 hz (5 seconds a cycle) up to 18k hz
  • Very Stable, Temperature compensated circuit
  • Waveform outputs: 10vpp
  • Width: 4HP
  • Depth: 45mm
  • Current consumption: +12v 20mA, -12v 38mA


Additional information

Weight 0.03137 kg

You may also like…