Description
NOT A DIY PRODUCT – BUILT AND TESTED BY 4MS IN PORTLAND, OR, USA.
Row Power is a clean, regulated, and protected power solution for eurorack systems.
The Row Power 25 provides 25W of power for a small system of eurorack modules (typically 4-10 modules*):
- +12V @ 1.4A maximum, 1.0A recommended
- -12V @ 0.8A maximum, 0.5A recommended
- +5V @ 1.0A maximum, 0.8A recommended
*number of modules can vary depending on each module’s power consumption.
Simply plug a laptop style power supply into either of the barrel plugs on the 4HP panel. Connect your modules via flying-bus cables, or connect the Row Power to a Distro Board.
Daisy-chain multiple Row Powers to use a single power brick for multiple rows. Each row will be independently regulated and protected for ultra-low cross-talk between rows. Rows can also be hot-swapped (plugged/unplugged without powering the whole system down).
Row Power 25 – User Manual
SYSTEM EXAMPLES
For any system you need at least these four items
- One Row Power Module
- One Distribution device (BusStick or Flying Bus Cable)
- One PSU Brick
- One PSU Cord
Then optionally if you want to daisy chain multiple row power modules you need
- A Link Cable – DC Jumper – available HERE
EXAMPLE
A single row (up to 104hp) of Eurorack
- One Row Power 25 Module
- One Male Bus Cable
- One 45w PSU Block
- One PSU Cord (EU, UK or USA)
Row Power 25 Features
- Two power jacks for daisy-chaining multiple Row Powers and Pods: a common laptop-style power brick could power 3-5 rows (typical)
- On/off switch cuts power without interrupting the daisy-chain
- LED light indicates module is on
- Row Power 25 typically will provide enough power for 4-10 modules (this can vary, based on each module’s power consumption)
- Row Power 25 is efficient, so it won’t heat up your system.
- Skiff-friendly: only 25.6mm (1.01″) with power connector installed.
- Includes set of easily soldered holes for custom distribution systems (by soldering wires or MTA156 connectors)
All further technical questions related to the product should be sent to [email protected]
